'

Search results

Found 1101 matches
Allowable Strength Design Load combination (eq6b)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Ballistic Coefficient - using corss-sectional area

In ballistics, the ballistic coefficient (BC) of a body is a measure of its ability to overcome air resistance in flight. It is inversely proportional to ... more

Simplified von Mises equation - Pure shear

RESTRICTIONS : σ₁ = σ₂ = σ₃ = 0, σ₃₁ = σ₂₃ = 0

The von Mises yield criterion suggests that the yielding of materials ... more

Electrical resistance

Electrical resistance of an electrical conductor is the opposition to the passage of an electric current through that conductor and depends on: What ... more

Simplified von Mises equation - Principal plane stress

RESTRICTIONS : σ₃ = 0, σ₁₂ = σ₁₃ = σ₂₃ = 0

The von Mises yield criterion suggests that the yielding of materials begins ... more

Cross Section

The cross section is an effective area that quantifies the intrinsic likelihood of a scattering event when an incident beam strikes a target object, made ... more

Drift Velocity (with current and conductor section area)

The drift velocity is the average velocity that a particle, such as an electron, attains in a material due to an electric field. It can also be referred to ... more

Sag curve length when S<L (Vertical curves for highway design)

When a driver is driving on a sag curve at night, the sight distance is limited by the higher grade in front of the vehicle. This distance must be long ... more

Sag curve length when S>L (Vertical curves for highway design)

When a driver is driving on a sag curve at night, the sight distance is limited by the higher grade in front of the vehicle. This distance must be long ... more

Simplified von Mises equation - Principal stresses

RESTRICTIONS : σ₁₂ = σ₁₃ = σ₂₃ = 0

The von Mises yield criterion suggests that the yielding of materials begins when the ... more

...can't find what you're looking for?

Create a new formula