Search results
Alternating current power depends on the voltage and the load resistance
... more
The maximum depressurisation for a dynamically insulated building is normally limited to 10 Pa in order to avoid doors slamming shut or difficulty in ... more
In physics, the Young – Laplace equation, is a nonlinear partial differential equation that describes the capillary pressure difference sustained ... more
In the design of fluid bearings, the Sommerfeld number (S), or bearing characteristic number, is a dimensionless quantity used extensively in hydrodynamic ... more
The design of buildings must account for wind loads, and these are affected by wind shear. For engineering purposes, a power law wind speed profile may be ... more
A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more
Porosity or void fraction is a measure of the void (i.e., “empty”) spaces in a material, and is a fraction of the volume of voids over the ... more
The selection of synthetic membranes for a targeted separation process is usually based on few requirements. Membranes have to provide enough mass transfer ... more
In electrical engineering, three-phase electric power systems have at least three conductors carrying alternating current voltages that are offset in time ... more
For the root mean square value of the ripple voltage, the calculation is more involved as the shape of the ripple waveform has a bearing on the result. ... more
...can't find what you're looking for?
Create a new formula