Search results
Power is the rate of doing work. It is equivalent to an amount of energy consumed per unit time. The same amount of work is done when carrying a load up a ... more
(a) The figure shows the forearm of a person holding a book. The biceps exert a force FB to support the weight of the forearm and the book. The triceps are assumed to be relaxed. (b) Here, you can view an approximately equivalent mechanical system with the pivot at the elbow joint
Strategy
There are four forces acting on the forearm and its load (the system of interest). The magnitude of the force of the biceps is FB, that of the elbow joint is FE, that of the weights of the forearm is wa , and its load is wb. Two of these are unknown FB, so that the first condition for equilibrium cannot by itself yield FB . But if we use the second condition and choose the pivot to be at the elbow, then the torque due to FE is zero, and the only unknown becomes FB .
Solution
The torques created by the weights are clockwise relative to the pivot, while the torque created by the biceps is counterclockwise; thus, the second condition for equilibrium (net τ = 0) becomes
Note that sin θ = 1 for all forces, since θ = 90º for all forces. This equation can easily be solved for FB in terms of known quantities,yielding. Entering the known values gives
which yields
Now, the combined weight of the arm and its load is known, so that the ratio of the force exerted by the biceps to the total weight is
Discussion
This means that the biceps muscle is exerting a force 7.38 times the weight supported.
Reference : OpenStax College,College Physics. OpenStax College. 21 June 2012.
http://openstaxcollege.org/textbooks/college-physics
Creative Commons License : http://creativecommons.org/licenses/by/3.0/
The hardness number is determined by the load over the surface area of the indentation and not the area normal to the force, and is therefore not ... more
Contact mechanics is the study of the deformation of solids that touch each other at one or more points. Hertzian contact stress refers to the localized ... more
In ductile materials, a plastic zone develops at the tip of the crack. The plastic loading and unloading cycle near the crack tip leads to the dissipation ... more
In probability theory and statistics, the gamma distribution is a two-parameter family of continuous probability distributions. The parameterization with k ... more
Security characteristic line (SCL) is a regression line, plotting performance of a particular security or portfolio against that ... more
The Rouse number (P or Z) is a non-dimensional number in fluid dynamics which is used to define a concentration profile of suspended sediment and which ... more
Dolbear’s law states the relationship between the air temperature and the rate at which crickets chirp. It was formulated by Amos ... more
Dolbear’s law states the relationship between the air temperature and the rate at which crickets chirp. It was formulated by Amos ... more
...can't find what you're looking for?
Create a new formula
Calculate the force the biceps muscle must exert to hold the forearm and its load as shown in the figure below, and compare this force with the weight of the forearm plus its load. You may take the data in the figure to be accurate to three significant figures.