Search results
The series RLC can be analyzed for both transient and steady AC state behavior using the Laplace transform. If the voltage source ... more
Colpitts oscillator is an oscillator that uses an LC circuit (also called a resonant circuit, tank circuit, or tuned circuit) combined with a transistor ... more
Damping is caused by the resistance in the circuit. It determines whether or not the circuit will resonate naturally. Circuits which will resonate in this ... more
In microwave and radio-frequency engineering, a stub or resonant stub is a length of transmission line or waveguide that is connected at one end only. The ... more
In microwave and radio-frequency engineering, a stub or resonant stub is a length of transmission line or waveguide that is connected at one end only. The ... more
An LC circuit, also called a resonant circuit, tank circuit, or tuned circuit, is an electric circuit consisting of an inductor, represented by the letter ... more
An LC circuit, also called a resonant circuit, tank circuit, or tuned circuit, is an electric circuit consisting of an inductor, represented by the letter ... more
In electrical and electronic systems, reactance is the opposition of a circuit element to a change of electric current or voltage, due to that ... more
In electrical and electronic systems, reactance is the opposition of a circuit element to a change of electric current or voltage, due to that ... more
Self inductance factor of a solenoid depends on the number of turns, the cross section area, the length of the solenoid and the material within the solenoid
... more
A capacitor is an electrical/electronic device that can store energy in the electric field between a pair of conductors. Its capacity depends on the ... more
A solenoid is a coil wound into a tightly packed helix. In physics, the term refers specifically to a long, thin loop of wire, often wrapped around a ... more
Roll-off is the steepness of a transmission function with frequency, particularly in electrical network analysis, and most especially in connection with ... more
It is defined as the peak energy stored in the circuit divided by the average energy dissipated in it per cycle at resonance; Q factor is directly ... more
Capacitance is the ability of a body to store an electrical charge. Any object that can be electrically charged exhibits capacitance. The capacitance is a ... more
A supercapacitor (SC) (sometimes ultracapacitor, formerly electric double-layer capacitor (EDLC)) is a high-capacity ... more
A supercapacitor (SC) (sometimes ultracapacitor, formerly electric double-layer capacitor (EDLC)) is a high-capacity ... more
In magnetostatics, the force of attraction or repulsion between two current-carrying wires is often called Ampère’s force law. The ... more
The drift velocity is the average velocity that a particle, such as an electron, attains due to an electric field. In general, an electron will 'rattle ... more
The capacitance of a two parallel plates capacitor both of area A separated by a distance d is calculated by the area of overlap of the two plates, ... more
In physics and engineering, the time constant, usually denoted by the Greek letter (tau), is the parameter characterizing the response to a step input of ... more
The amount of electrical charge that must be added to an isolated conductor to raise its electrical potential by one unit
... more
In physics and engineering, the time constant, usually denoted by the Greek letter (tau), is the parameter characterizing the response to a step input of ... more
Electrical impedance is the measure of the opposition that a circuit presents to a current when a voltage is applied. The term complex impedance may be ... more
In engineering, deflection is the degree to which a structural element is displaced under a load. It may refer to an angle or a distance.
The angle of
... more
Components of an electrical circuit or electronic circuit can be connected in many different ways. The two simplest of these are called series and parallel ... more
Components of an electrical circuit or electronic circuit can be connected in many different ways. The two simplest of these are called series and parallel ... more
If two or more components are connected in parallel they have the same potential difference (voltage) across their ends. The potential differences across ... more
...can't find what you're looking for?
Create a new formula