'

Search results

Found 1857 matches
Declination of the Sun (simplified)

The position of the Sun in the sky is a function of both time and the geographic coordinates of the observer on the surface of the Earth. As the Earth ... more

Vertical Hyperbola (Standard Equation)

Hyperbola is the set of all points in the plane, such that the absolute value of the difference of each of the distances from two fixed points is constant. ... more

Horizontal Hyperbola (Standard Equation)

Hyperbola is the set of all points in the plane, such that the absolute value of the difference of each of the distances from two fixed points is constant. ... more

Standard logistic sigmoid function (k=1, x0=0, L=1)

A logistic function or logistic curve is a common “S” shape (sigmoid curve). Data that follows an increasing logistic curve usually describes ... more

Torsion constant (Circle -cross-sectional shape)

In solid mechanics, torsion is the twisting of an object due to an applied torque. The torsion constant is a geometrical property of a bar’s ... more

Couple balance

Rotating unbalance is the uneven distribution of mass around an axis of rotation. A rotating mass, or rotor, is said to be out of balance when its center ... more

Perimeter of a deltoid

In geometry, a deltoid, also known as a tricuspoid or Steiner curve, is a hypocycloid of three cusps. In other words, it is the roulette created by a point ... more

Curved Area of a Frustum of a Right Circulacircular Cone

The curved area of the frustum cone, can be calculated from the radius of the lower base and the radius of the upper base and the height of the cone (the ... more

Darcy friction factor - Blasius correlation with correction for curved or helically coiled tubes (Variable Rc)

In fluid dynamics, the Darcy friction factor ormulae are equations that allow the calculation of the Darcy friction factor, a dimensionless quantity used ... more

Geometrical requirements for pin ended members - Given thickness

This formula calculates the geometrical requirements for pin ended members, specifically the minimum required distances from the pin hole edge to the plate ... more

...can't find what you're looking for?

Create a new formula