Search results
A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more
This formula calculates the geometrical requirements for pin ended members, specifically the minimum required distances from the pin hole edge to the plate ... more
A mechanical joint is a part of a machine which is used to connect another mechanical part or mechanism. Mechanical joints may be temporary or permanent. ... more
A piston is the moving component that is contained by a cylinder and is made gas-tight by piston rings. In an engine, its purpose is to transfer force from ... more
A piston is the moving component that is contained by a cylinder and is made gas-tight by piston rings. In an engine, its purpose is to transfer force from ... more
A piston is the moving component that is contained by a cylinder and is made gas-tight by piston rings. In an engine, its purpose is to transfer force from ... more
A crank is an arm attached at right angles to a rotating shaft by which reciprocating motion is imparted to or received from the shaft. It is used to ... more
Column or pillar in architecture and structural engineering is a structural element that transmits, through compression, the weight of the structure above ... more
A threaded rod, also known as a stud, is a relatively long rod that is threaded on both ends; the thread may extend along the complete length of the ... more
A pressure vessel is a closed container designed to hold gases or liquids at a pressure substantially different from the ambient pressure.
When a
... more
...can't find what you're looking for?
Create a new formula