'

Search results

Found 1564 matches
Shear rate at the inner wall of a Newtonian fluid (flowing within a pipe)

A Newtonian fluid is a fluid in which the viscous stresses arising from its flow, at every point, are proportional to the local strain rate — the rate of ... more

Hydrostatic Pressure - simplified version

In a fluid at rest, all frictional stresses vanish and the state of stress of the system is called hydrostatic.For water and other liquids, this integral ... more

Kinematic Viscosity

Viscosity is a property arising from collisions between neighboring particles in a fluid that are moving at different velocities. When the fluid is forced ... more

Dynamic (shear) viscosity

The dynamic (shear) viscosity of a fluid expresses its resistance to shearing flows, where adjacent layers move parallel to each other with different ... more

Bearing capacity - Terzaghi's Theory (Variable Nq)

In geotechnical engineering, bearing capacity is the capacity of soil to support the loads applied to the ground. The bearing capacity of soil is the ... more

Bearing capacity for square foundations (Terzaghi's Theory)

In geotechnical engineering, bearing capacity is the capacity of soil to support the loads applied to the ground. The bearing capacity of soil is the ... more

Bearing capacity for circular foundations (Terzaghi's Theory)

In geotechnical engineering, bearing capacity is the capacity of soil to support the loads applied to the ground. The bearing capacity of soil is the ... more

Bearing capacity for continuous foundations (Terzaghi's Theory)

In geotechnical engineering, bearing capacity is the capacity of soil to support the loads applied to the ground. The bearing capacity of soil is the ... more

Velocity in Frictionless Banked Turn

A banked turn (aka. banking turn) is a turn or change of direction in which the vehicle banks or inclines, usually towards the inside of the turn. For a ... more

Horizontal Curve - Allowable radius

The allowable radius for a horizontal curve can then be determined by knowing the intended design velocity, the coefficient of friction, and the allowed ... more

...can't find what you're looking for?

Create a new formula