'

Search results

Found 1360 matches
Spring constant

Hooke’s law is a principle of physics that states that the force F needed to extend or compress a spring by some distance X is proportional to that ... more

Wing loading - turning radius

In aerodynamics, wing loading is the total weight of an aircraft divided by the area of its wing. The stalling speed of an aircraft in straight, level ... more

Simplified von Mises equation - Pure shear

RESTRICTIONS : σ₁ = σ₂ = σ₃ = 0, σ₃₁ = σ₂₃ = 0

The von Mises yield criterion suggests that the yielding of materials ... more

Hooke's Law (spring)

Hooke’s Law of elasticity is an approximation that states that the amount by which a material body is deformed (the strain) is linearly related to ... more

Shear rate

Shear rate is the rate at which a progressive shearing deformation is applied to some material. The shear rate for a fluid flowing between two parallel ... more

Lambert cylindrical equal-area projection(X-coordinate)

In cartography, the Lambert cylindrical equal-area projection, or Lambert cylindrical projection, is a cylindrical, equal area map projection. It is a ... more

Johnson-Kendall-Roberts (JKR) model of elastic contact between two spheres ( pull-off force)

Contact mechanics is the study of the deformation of solids that touch each other at one or more points.When two solid surfaces are brought into close ... more

Creep (deformation)

In materials science, creep (sometimes called cold flow) is the tendency of a solid material to move slowly or deform permanently under the influence of ... more

Margin of safety (measure of requirement verification)

Many government agencies and industries (such as aerospace) require the use of a margin of safety (MoS or M.S.) to describe the ratio of the strength of ... more

Time to reach specific temperature (related to Biot and Fourier numbers)

The Biot number (Bi) is a dimensionless quantity used in heat transfer calculations. Gives a simple index of the ratio of the heat transfer resistances ... more

...can't find what you're looking for?

Create a new formula