'

Search results

Found 830 matches
Allowable Strength Design Load combination (eq3)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Freezing point depression (cryoscopy)

Colligative properties are properties of solutions that depend upon the ratio of the number of solute particles to the number of solvent molecules in a ... more

Force between two bar magnets

The Gilbert model assumes that the magnetic forces between magnets are due to magnetic charges near the poles. This model produces good approximations that ... more

Orbital Period - as a function of central body's density

The orbital period is the time taken for a given object to make one complete orbit around another object.

When mentioned without further ... more

Alfvén velocity

In plasma physics, an Alfvén wave, named after Hannes Alfvén, is a type of magnetohydrodynamic wave in which ions oscillate in response to a restoring ... more

Permeability of a material to air flow

The maximum depressurisation for a dynamically insulated building is normally limited to 10 Pa in order to avoid doors slamming shut or difficulty in ... more

Velocity of a falling object

In fluid dynamics, drag (sometimes called air resistance, a type of friction, or fluid resistance, another type of friction or fluid friction) is a force ... more

Hydrostatic weighing

Hydrostatic weighing, also referred to as “underwater weighing,” “hydrostatic body composition analysis,” and ... more

Darcy friction factor - Colebrook–White equation (relative to the radius)

In fluid dynamics, the Darcy friction factor formulae are equations that allow the calculation of the Darcy friction factor, a dimensionless quantity used ... more

Force between two nearby magnetized surfaces (relative to flux density)

The Gilbert model assumes that the magnetic forces between magnets are due to magnetic charges near the poles. This model produces good approximations that ... more

...can't find what you're looking for?

Create a new formula