'

Search results

Found 840 matches
Kepler's Third Law

In astronomy, Kepler’s laws of planetary motion are three scientific laws describing the motion of planets around the Sun.

1.The orbit of a ... more

Ripple voltage (full-wave rectifier))

The most common meaning of ripple in electrical science is the small unwanted residual periodic variation of the direct current (DC) output of a power ... more

Net Thrust of a Rocket Engine

A rocket engine, or simply “rocket”, is a jet engine that uses only stored propellant mass for forming its high speed propulsive jet. Rocket ... more

Ripple voltage (half-wave rectifier))

The most common meaning of ripple in electrical science is the small unwanted residual periodic variation of the direct current (DC) output of a power ... more

Auger electron spectroscopy - electron impact cross-section

Auger electron spectroscopy is a common analytical technique used specifically in the study of surfaces and, more generally, in the area of materials ... more

Auger electron spectroscopy - Electron impact cross-section (account for matrix effects)

Auger electron spectroscopy is a common analytical technique used specifically in the study of surfaces and, more generally, in the area of materials ... more

Saturated Adiabatic Lapse Rate

The lapse rate is defined as the rate at which atmospheric temperature decreases with increase in altitude. The terminology arises from the word lapse in ... more

Miles Equation

In 1954, Miles developed his version of this equation for GRMS as he was researching fatigue failure of aircraft structural ... more

Infiltration

Infiltration is the process by which water on the ground surface enters the soil. Infiltration rate in soil science is a measure of the rate at which soil ... more

R-value (insulation) of a multi-layered installation - U.S. units

The R-value is a measure of thermal resistance, or ability of heat to transfer from hot to cold, through materials (such as insulation) and assemblies of ... more

...can't find what you're looking for?

Create a new formula