'

Search results

Found 1443 matches
Time to reach specific temperature (related to Biot and Fourier numbers)

The Biot number (Bi) is a dimensionless quantity used in heat transfer calculations. Gives a simple index of the ratio of the heat transfer resistances ... more

Isentropic Relations for an Ideal Gas - difference entropy relative to the pressure

In thermodynamics, an isentropic process is an idealized thermodynamic process that is adiabatic and in which the work transfers of the system are ... more

Darcy friction factor - Blasius correlation

In fluid dynamics, the Darcy friction factor formulae are equations that allow the calculation of the Darcy friction factor, a dimensionless quantity used ... more

Dittus-Boelter equation - Nusselt number

In heat transfer at a boundary (surface) within a fluid, the Nusselt number (Nu) is the ratio of convective to conductive heat transfer across (normal to) ... more

Diffusion Coefficient - related to Fick's laws of diffusion

Diffusion is the net movement of a substance (e.g., an atom, ion or molecule) from a region of high concentration to a region of low concentration. This is ... more

Flow coefficient

The flow coefficient of a device is a relative measure of its efficiency at allowing fluid flow. It describes the relationship between the pressure drop ... more

Isentropic Relations for an Ideal Gas - Temperature and density

In thermodynamics, an isentropic process is an idealized thermodynamic process that is adiabatic and in which the work transfers of the system are ... more

Diffusion Coefficient for two different gases (related to Fick's laws)

Diffusion is the net movement of a substance (e.g., an atom, ion or molecule) from a region of high concentration to a region of low concentration. For two ... more

Darcy's Law for membrane performance application

The selection of synthetic membranes for a targeted separation process is usually based on few requirements. Membranes have to provide enough mass transfer ... more

Channel bed pressure (at the bed of an open channel)

The depth–slope product is used to calculate the shear stress at the bed of an open channel containing fluid that is undergoing steady, uniform flow. The ... more

...can't find what you're looking for?

Create a new formula