'

Search results

Found 1521 matches
Auger electron spectroscopy - emitted electron kinetic energy

Auger electron spectroscopy is a common analytical technique used specifically in the study of surfaces and, more generally, in the area of materials ... more

Drift Velocity

The drift velocity is the average velocity that a particle, such as an electron, attains in a material due to an electric field. It can also be referred to ... more

Ballistic Coefficient - using corss-sectional area

In ballistics, the ballistic coefficient (BC) of a body is a measure of its ability to overcome air resistance in flight. It is inversely proportional to ... more

Properties of concrete - modulus of elasticity

Concrete has relatively high compressive strength, but significantly lower tensile strength. As a result, without compensating, concrete would almost ... more

Loss due to Antenna Misalignment

Antenna measurement techniques refers to the testing of antennas to ensure that the antenna meets specifications or simply to characterize it. Typical ... more

Optical depth

In physics, optical depth or optical thickness, is the natural logarithm of the ratio of incident to transmitted radiant power through a material, and ... more

Horizontal Curve - Degree of curve

Aside from momentum, when a vehicle makes a turn, two forces are acting upon it. The first is gravity, which pulls the vehicle toward the ground. The ... more

Self-inductance factor

Self inductance factor of a solenoid depends on the number of turns, the cross section area, the length of the solenoid and the material within the solenoid

... more

Darcy's Law for membrane performance application

The selection of synthetic membranes for a targeted separation process is usually based on few requirements. Membranes have to provide enough mass transfer ... more

Rayleigh range ( confocal parameter)

In optics and especially laser science, the Rayleigh length or Rayleigh range is the distance along the propagation direction of a beam from the waist to ... more

...can't find what you're looking for?

Create a new formula