'

Search results

Found 1984 matches
Cross Section (flux)

The cross section is an effective area that quantifies the intrinsic likelihood of a scattering event when an incident beam strikes a target object, made ... more

Preload (cardiac)

Preload is described as the stretching of a single cardiac myocyte immediately prior to contraction and is, therefore, related to the sarcomere length. ... more

Cycloid (Cartesian equation)

A cycloid is the curve traced by a point on the rim of a circular wheel as the wheel rolls along a straight line without slippage. It is an example of a ... more

Radius of sphere tangent to edges of a cube

The radius of the sphere tangent to the edges of the cube is related to the length of the edge of the cube

... more

Heat transfer rate for a pipe with a fluid flowing inside.

The rate of heat transfer between the bulk of the fluid inside the pipe and the pipe external surface is related to the pipe surface area, the wall ... more

Lean angle due to a tire thickness of a bicycle

The finite width of the tires alters the actual lean angle of the rear frame from the ideal lean angle described above. The actual lean angle between the ... more

Klein bagel ( "figure 8" immersion x-coordinate)

In mathematics, the Klein bottle is an example of a non-orientable surface, informally, it is a surface (a two-dimensional manifold) in which notions of ... more

Klein bagel ( "figure 8" immersion y-coordinate)

In mathematics, the Klein bottle is an example of a non-orientable surface, informally, it is a surface (a two-dimensional manifold) in which notions of ... more

Allowable Strength Design Load combination (eq1)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

Load and Resistance Factor Design (LRFD) - Load combinations (eq5)

In structural engineering, a structure is a body or combination of pieces of rigid bodies in space to form a fitness system for supporting loads. ... more

...can't find what you're looking for?

Create a new formula