Search results

Found 1287 matches
Cantilever Euler Beam - Displacement

Euler–Bernoulli beam theory (also known as engineer’s beam theory or classical beam theory) is a simplification of the linear theory of elasticity ... more

Self-buckling critical height ( for a free-standing, vertical column)

Column or pillar in architecture and structural engineering is a structural element that transmits, through compression, the weight of the structure above ... more

Knuckle joint (Maximum bending stress)

A knuckle joint is a mechanical joint used to connect two rods which are under a tensile load, when there is a requirement of small amount of flexibility, ... more

Curvature of a Bimetallic Beam

A bimetallic strip is used to convert a temperature change into mechanical displacement. The strip consists of two strips of different metals which expand ... more

Beam shear

Shear stress,is defined as the component of stress coplanar with a material cross section. The average shear stress is force per unit area. Beam shear is ... more

Maximum deflection distance of an off-center loaded beam supported by two simple supports

In engineering, deflection is the degree to which a structural element is displaced under a load.
This maximum deflection occurs at a distance x_1 ... more

Beam (nautical)

The beam of a ship is its width at the widest point as measured at the ship’s nominal waterline. The beam is defined as a bearing projected at ... more

Shaft bending moment due to yaw (2-bladed rotor)

The shaft bending moment due to yaw depends on the blades of the rotor. In this case the rotor has 2 blades

... more

Micro chevron (MC) test (critical energy release rate)

The wafer bond characterization is based on different methods and tests. Wafer bonds are commonly characterized by three important encapsulation ... more

Blade root bending moment load due to yaw

The blade root bending moment due to the wind turbine yaw operation. The yaw rate can be calculated for passive yaw, or is defined by the design for active ... more

...can't find what you're looking for?

Create a new formula