'

Search results

Found 644 matches
Gauge factor

Strain gauge is a device used to measure strain on an object. A strain is a normalized measure of deformation representing the displacement between ... more

Triangular Prism Volume

A triangular prism is a three-sided prism; it is a polyhedron made of a triangular base, a translated copy, and 3 faces joining corresponding sides.
... more

Force on a Contact Area between two cylinders with parallel axes

Contact mechanics is the study of the deformation of solids that touch each other at one or more points. Hertzian contact stress refers to the localized ... more

Maximum value of bending moments for a center loaded beam supported by two simple supports

A bending moment is the reaction induced in a structural element when an external force or moment is applied to the element causing the element to bend. ... more

Thrust (with cross section area)

Thrust is a reaction force described quantitatively by Newton’s second and third laws. When a system expels or accelerates mass in one direction, the ... more

Depth of the contact region between a rigid conical indenter and an elastic half-space

Contact mechanics is the study of the deformation of solids that touch each other at one or more points. Hertzian contact stress refers to the localized ... more

NTU method - actual heat transfer rate (q) (relative to the hot fluid)

The Number of Transfer Units (NTU) Method is used to calculate the rate of heat transfer in heat exchangers (especially counter ... more

NTU method - actual heat transfer rate (q) (relative to the cold fluid)

The Number of Transfer Units (NTU) Method is used to calculate the rate of heat transfer in heat exchangers (especially counter ... more

Chebychev–Grübler–Kutzbach criterion

The Chebychev–Grübler–Kutzbach criterion determines the degree of freedom of a kinematic chain, that is, a coupling of rigid bodies by means of mechanical ... more

Margin of safety for failure load (measure of requirement verification)

Many agencies and organizations (such as aerospace) define the margin of safety (MoS or M.S.) including the design factor, in other words, the margin of ... more

...can't find what you're looking for?

Create a new formula